All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise without the prior permission of Philips. Published by BB 0469 Service PaCE...
EN 2 L04E AB Technical Specifications, Connections, and Chassis Overview 1. Technical Specifications, Connections, and Chassis Overview Notes: Connections • Described specifications are valid for the whole product range. Note: The following connector colour abbreviations are used • Figures below can deviate slightly from the actual situation, (acc.
Page 3
Technical Specifications, Connections, and Chassis Overview L04E AB EN 3 External 1: RGB/YUV - In and CVBS - In/Out External 2: CVBS- In and SVHS - In E_06532_001.eps E_06532_001.eps 050404 050404 Figure 1-3 SCART connector Figure 1-4 SCART connector - Audio - R 0.5 V_rms / 1 kohm...
EN 4 L04E AB Safety Instructions, Warnings, and Notes 2. Safety Instructions, Warnings, and Notes – Safety Instructions Complete kit ESD3 (small tablemat, wristband, connection box, extension cable and ground cable) 4822 310 10671. Safety regulations require that during a repair: –...
Page 5
Lead Free Solder Some PWBs in this chassis are “lead-free prepared”. This is indicated on the PWB by the PHILIPS lead-free logo (either by a service-printing or by a sticker). It does not mean that lead- free solder is actually used!
4. Module Re-assembly Notes: • Only the digital module disassembly is described. For other disassembly instructions, see the Service manual for L04E AA 3122 785 14480. • Figures below can deviate slightly from the actual situation, due to different set executions. •...
EN 8 L04E AB Service Modes, Error Codes, and Fault Finding 5. Service Modes, Error Codes, and Fault Finding Index: Table 5-2 Software cluster overview 1. Test Points. 2. Service Modes. SW Clusters SW Version First Mask Remarks 3. Problems and Solving Tips (related to CSM).
Page 9
Service Modes, Error Codes, and Fault Finding L04E AB EN 9 After activating SDM, the following screen is visible, with SDM After activating SAM, the following screen is visible, with SAM in the upper right corner of the screen to indicate that the in the upper right corner of the screen to indicate that the television is in Service Default Alignment Mode.
Page 10
EN 10 L04E AB Service Modes, Error Codes, and Fault Finding 13. Audio. No audio alignment is necessary for this television Upon activating the Customer Service Mode, the following set. screen will appear: 14. NVM Editor. Used to change the NVM data in the television set.
Page 11
Service Modes, Error Codes, and Fault Finding L04E AB EN 11 5. Bit Error Rate: The error rate measured before the error Menu explanation correction algorithm circuitry. (this value gives an impression of the received signal) 6. Tuner AGC: Tuner AGC value.
Page 12
Introduction twice to exit the user menu. 8. The new PERSONAL preference value is automatically ComPair (Computer Aided Repair) is a service tool for Philips stored. Consumer Electronics products. ComPair is a further development on the European DST (service remote control), Snowy picture which allows faster and more accurate diagnostics.
Service Modes, Error Codes, and Fault Finding L04E AB EN 13 Example: Measure the DC-voltage on capacitor C2568 Error Codes (Schematic/Panel) at the Mono-carrier. – Click on the 'Panel' hyperlink to automatically show the The error code buffer contains all errors detected since the last PWB with a highlighted capacitor C2568.
EN 14 L04E AB Service Modes, Error Codes, and Fault Finding Table 5-3 Error codes overview Error Device Error description Check item Diagram Not applicable No Error Not applicable X-Ray / over-voltage protection (US only) 2411, 2412, 2413, 6404, 6411, 6412.
Page 15
Service Modes, Error Codes, and Fault Finding L04E AB EN 15 Fault Finding and Repair Tips Set Does Not Start Up Set Unable to Start Notes: • It is assumed that the components are mounted correctly with correct values and no bad solder joints.
Page 16
EN 16 L04E AB Service Modes, Error Codes, and Fault Finding 5.8.4 Deflection Blank Screen One Thin Vertical Line Blank Screen Quick check: • Set in protection mode. • LED blinking with error “3”. Check Vg2 Picture (fine tune) appears?
Page 17
Service Modes, Error Codes, and Fault Finding L04E AB EN 17 5.8.6 Tuner and IF Picture Ok, No Sound No Picture Picture Ok, No Sound 1. Check that the Option settings are correct. 2. If correct, check that supply voltages are there.
Page 18
EN 18 L04E AB Service Modes, Error Codes, and Fault Finding 5.8.7 5.8.9 Controller Audio Processing Below are some guidelines for troubleshooting of the Micro No Sound Controller function. Normally Micro Controller should be checked when there is a problem of startup.
Block Diagrams, Testpoint Overviews, and Waveforms L04E AB Block Diagram Video IBO-ZAPPER K1 K2 K3 K4 FRONT END ANALOG BACK END LTI/CTI CONN. 7611 7610 +5VClean 7630 MM1389XFBE TDA9178T 7635 7636 1212 1212 F216 1212 INTF_Y_OUT 1214 CLAMP INTF_Y/GREEN_IN GREEN/Y...
Block Diagrams, Testpoint Overviews, and Waveforms L04E AB I2C and Supply Voltage Overview SUPPLY LINES DIAGRAM POWER SUPPLY LINE + FRAME DEFLECTION CRT INTF SCAVEM ANALOG BACK END 1405 6401 1383 7541 +Vbatt +Vbatt 1534 FILAMENT 1503 +12V ENERGIZING V_DG...
Circuit Diagrams and PWB Layouts L04E AB Mono Carrier: Diversity Table for A1 (Power Supply) DIVERSITY TABLE FOR POWER SUPPLY REGION NAFTA LATAM / AP CHINA INDIA EUROPE MAIN RANGE 27RF 26WSRF 25RF 28WSRF 21/29RF 29RF 24WR 27FSQ 32RF 30WSRF...
Circuit Diagrams and PWB Layouts L04E AB Mono Carrier: Diversity Table for A2 (Deflection) DIVERSITY TABLE FOR DEFLECTION Region NAFTA LATAM CHINA INDIA Tube SMGK SMGK SMGK Size 27 V 28 WR 29 RF 32 V 32 V RF 32 WR...
Circuit Diagrams and PWB Layouts L04E AB Top Control Panel (FL-13) Layout Top Control Panel (FL-13) Bottom 1010 A1 TOP CONTROL (FL-13) 1011 B3 1012 B3 1013 B2 FROM 1682 1010 1014 B3 1015 B2 F011 KEY_PROTN 3010 A1 FROM 1281...
Circuit Diagrams and PWB Layouts L04E AB IBO Zapper Panel: Analog Back End 1004 C14 5514 I4 1206 A14 5518 C11 1212 H14 5519 C11 1219 F14 5520 D13 1534 B14 6501 E11 ANALOG BACK END 2500 A8 6502 G11...
Alignments L04E AB EN 71 8. Alignments 5. SATURATION/COLOR to “0”. Index of this chapter: 1. General Alignment Conditions 6. CONTRAST to “0”. 2. Hardware Alignments 7. BRIGHTNESS to minimum (OSD just visible). 3. Software Alignments and Settings 8. Return to the SAM via the MENU key.
Page 72
EN 72 L04E AB Alignments Software Alignments and Settings E_14480_143.eps 260504 Figure 8-3 Service Mode overview...
Page 73
Alignments L04E AB EN 73 Enter the Service Alignment Mode (see also chapter 5 “Service How to calculate the value of an Option Byte • Modes, ..”). The SAM menu will now appear on the screen. Calculate an Option Byte value (OP1 .. OP7) in the...
Page 75
0 : ALPS / MASCO compatible tuner is in use for PIP – OB73: Reserved (value= 0) module. – OB72: Reserved (value= 0) – 1 : Philips compatible tuner is in use for PIP module. – OB71: Reserved (value= 0) • OB20: HUE – OB70: Reserved (value= 0) –...
Page 76
EN 76 L04E AB Alignments – • Note: Only for EU/AP region for sets with PIP. OB50: Reserved • – OB35: PIP SPLITTER Default setting is “0”. – 0 : Normal Tuner in PIP – 1 : Splitter in PIP Option Byte 6 (OP6) –...
Page 77
Alignments L04E AB EN 77 6. Adjust the AGC-value with the LEFT/ RIGHT cursor keys 1. Connect an external video pattern generator to the aerial until the voltage at pin 1 of the tuner lies between 3.8 and input of the TV-set and input a crosshatch test pattern. Set 2.3 V (default value is “20”).
• In this paragraph, only components and circuits of the “IBO Zapper” module (Intelligent Bolt On) are described. For the other circuit descriptions, see the L04E AA manual (3122 785 14480). • Only new circuits are described here. For the other circuit descriptions, see the A10E BB manual (3122 785 13940).
Page 80
EN 80 L04E AB Circuit Descriptions, List of Abbreviations, and IC Data Sheets • PNx83xx MOJO I2S Out: This digital sound output is fed through a DAC and the analogue L/R signals are directely fed into the Hercules. The MOJO is a source decoder chip targeted for very low cost application in integrated digital televisions.The device contains...
Circuit Descriptions, List of Abbreviations, and IC Data Sheets L04E AB EN 81 The module is in “On” or “Logical Standby” state. Dealer Service Tool: special remote • On state. In this state the module can perform the following control designed for dealers to enter pre-programmed functions: e.g.
Page 82
EN 82 L04E AB Circuit Descriptions, List of Abbreviations, and IC Data Sheets Serial Data SECAM SEequence Couleur Avec Memoire. Color system mainly used in France and East Europe. Color carriers = 4.406250 MHz and 4.250000 MHz Sound Intermediate Frequency...
Circuit Descriptions, List of Abbreviations, and IC Data Sheets L04E AB EN 83 9.11 IC Data Sheets This section shows the internal block diagrams and pin layouts of ICs that are drawn as "black boxes" in the electrical diagrams (with the exception of "memory" and "logic" ICs).
Page 84
EN 84 L04E AB Circuit Descriptions, List of Abbreviations, and IC Data Sheets 9.11.2 Diagram K6, TDA10046 (IC7600) INTERNAL BLOCK DIAGRAM AGC_TUN AGC_IF ANALOG DIGITAL FRONT-END ∆Σ CHANNEL ESTIMATION AND OFDM Dual AGC ∆Σ AND CORRECTION DEMODULATION OFDM Spectrum Fsamp...