All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise without the prior permission of Philips. Published by JH 0564 TV Service...
EN 2 L03.2L AA Technical Specifications, Connections and Chassis Overview 1. Technical Specifications, Connections and Chassis Overview Index of this chapter: Mini Jack: Audio Head phone - Out 1.1 Technical Specifications Bk - Head phone 8 - 600 ohm / <4 mW 1.2 Connection Overview...
Page 4
Technical Specifications, Connections and Chassis Overview L03.2L AA EN 3 Chassis Overview CRT PANEL POWER SUPPLY DEFLECTION TUNER IF IF, VIDEO PROCESSING, CONTROL, AND SYNC. MONO AUDIO BTSC STEREO DECODER CARRIER AUDIO AMP + MONO SOUND PROC. FRONT I/O + FRONT CONTROL + HEADPHONE E_14560_013.eps...
EN 4 L03.2L AA Safety Instructions, Warnings, and Notes 2. Safety Instructions, Warnings, and Notes Index of this chapter: 1. Perform the “general repair instruction” noted above. 2.1 Safety Instructions 2. Clean the power supply and deflection circuitry on the 2.2 Maintenance Instructions...
In case of doubt whether the board is lead-free or not (or with mixed technologies), you can use the following method: Philips CE is going to produce lead-free sets (PBF) from • Always use the highest temperature to solder, when using 1.1.2005 onwards.
EN 6 L03.2L AA Mechanical Instructions 4. Mechanical Instructions Index of this chapter: Rear Cover Mounting 4.1 Rear Cover Removal 4.2 Service Position Main Panel Before you mount the rear cover, perform the following checks: 4.3 Rear Cover Mounting 1. Check whether the mains cord is mounted correctly in its guiding brackets.
Service Modes, Error Codes, and Fault Finding L03.2L AA EN 7 5. Service Modes, Error Codes, and Fault Finding Index of this chapter: • All picture settings at 50 % (brightness, color contrast, 5.1 Test Points hue). 5.2 Service Modes •...
Page 9
The error buffer is not cleared. ComPair Problems and Solving Tips 5.4.1 Introduction ComPair (Computer Aided Repair) is a service tool for Philips 5.3.1 Picture Problems Consumer Electronics products. ComPair is a further development on the European DST (service remote control), Note: Below described problems are all related to the TV which allows faster and more accurate diagnostics.
Page 10
Service Modes, Error Codes, and Fault Finding L03.2L AA EN 9 connector (located on the Main panel, (see figure "Top view Mono Carrier" in chapter 8 "Alignments"). I 2 C SERVICE CONNECTOR The ComPair faultfinding program is able to determine the problem of the defective television.
Page 11
EN 10 L03.2L AA Service Modes, Error Codes, and Fault Finding Error Codes In case of non-intermittent faults, clear the error buffer before you begin the repair. These to ensure that old error codes are no longer present. If possible, check the entire contents of the error buffer. In some situations, an error code is only the result of another error code and not the actual cause (e.g., a fault in the protection...
Circuit Diagrams and PWB Layouts L03.2L AA EN 20 Mono Carrier: Front I/O + Front Control + Headphone 1100-A B1 1100-B C1 1101-A B2 1101-B C2 FRONT IO + FRONT CONTROL + HEADPHONE 1101-C D2 1181 B3 1182 C3 1183 C3...
Alignments L03.2L AA EN 27 8. Alignments Index of this chapter: 4. In the WHITE TONE sub menu, press the MENU UP/ 8.1 General Alignment Conditions DOWN keys to select NORMAL RED, NORMAL GREEN, 8.2 Hardware Alignments or NORMAL BLUE.
Page 29
EN 28 L03.2L AA Alignments 4. In the OPTIONS sub menu, press the MENU UP/DOWN keys to select 'OP 1' through 'OP 7'. 5. Use the number keys on the remote control transmitter to enter a new value for the selected option byte. The value must be entered as a three-digit value (for example, '4' max.
Page 30
FM radio feature is enabled LATAM & NAFTA: 0 OBx7 PHILIPS_TUNER ALPS / MASCO compatible tuner is in use Philips compatible tuner is in use LATAM & NAFTA: 0 OBx0 Hue/Tint Level is disabled or not applicable Hue/Tint Level is enabled LATAM &...
Page 31
EN 30 L03.2L AA Alignments Option Byte Option Bit Definition OP # Assignment Bit = [0] Bit = [1] Default setting OBx0 PIP or CLOCK Feature is disabled or not applicable Feature is enabled LATAM & NAFTA: 0 OBx1 HOTEL_MODE...
Page 32
Alignments L03.2L AA EN 31 8.3.2 Tuner CL (Cathode Drive Level) Fixed value is "7". Note: Described alignments are only necessary when the NVM (part reference number 7641) is replaced. 8.3.3 White Tone IFPLL The values of the 'black cut-off level' can be adjusted in the This adjustment is auto-aligned.
Page 33
EN 32 L03.2L AA Alignments 8.3.4 Geometry 12. When all desired changes to the HORIZONTAL and VERTICAL sub menu values are made, press the MENU button twice to return to the top level SDAM menu. Introduction 13. To ensure the GEOMETRY settings are saved: The geometry alignment menu contains several items for –...
Page 34
Alignments L03.2L AA EN 33 The table below lists the default GEOMETRY values for the – Turn the television set 'off' by using the 'POWER' different television sets. button on the remote control transmitter or the local keyboard. – Disconnect the television set from AC power for at Table 8-3 Default geometry values least ten seconds.
EN 34 L03.2L AA Circuit Descriptions, List of Abbreviations, and IC Data Sheets 9. Circuit Descriptions, List of Abbreviations, and IC Data Sheets Index of this chapter: Source Selection 9.1 Introduction 9.2 Source Selection The Source Select is divided mainly into two types, the "Mono 9.3 Audio...
Page 36
Circuit Descriptions, List of Abbreviations, and IC Data Sheets L03.2L AA EN 35 The volume level is controlled at this IC (pin 9) by the with the incoming CVBS signal. They are then fed to the H- and "VOLUME" control line coming from the microprocessor. After...
Page 37
EN 36 L03.2L AA Circuit Descriptions, List of Abbreviations, and IC Data Sheets Control This is of logic "high" (3.3 V) under normal operation of the TV. When the TV set is in Standby (or fault) condition, this signal is a continuous pulse of 5 ms "low"...
Circuit Descriptions, List of Abbreviations, and IC Data Sheets L03.2L AA EN 37 Abbreviation List and horizontal amplitude correction, beam current protection, and flash detection 2 Carrier Sound Electronic Program Guide; System Automatic Channel Installation: used by broadcasters to transmit TV...
Page 39
EN 38 L03.2L AA Circuit Descriptions, List of Abbreviations, and IC Data Sheets Power-On Reset; Signal to reset the µP Picture Tube Panel (or CRT-panel) Random Access Memory Remote Control transmitter Red, Green, and Blue colour space; The primary colour signals for TV. By...
EN 42 L03.2L AA Revision List 11. Revision List Manual xxxx xxx xxxx.0 • First release. Manual xxxx xxx xxxx.1 • Minor updates. – Text – IC Data sheet deleted. – Mapping CRT bottom side corrected.
Need help?
Do you have a question about the L03.2L AA and is the answer not in the manual?
Questions and answers