Step3
Step4
Auction: Wireless Client IP address must configure manually at the same subnet in Local Area
Network or enable DHCP server of M36 to retrieve IP automatically.
8.2 Repeater Mode
AP Repeater is used to extend the wireless coverage area of the Access Point. Please refer to the
previous section to configure the Access Point.
Repeater
Step1
Step2
Step3
Step4
Step5
Step6
Step7
Step8
Note(1): For more advanced settings, please refer to the previous chapters.
Note(2): Repeater IP subnet must the same as the Access Point, please refer to the IP Settings section for details.
Wireless Client
Step1
Step2
Step3
Configure VLAN ID in your wireless device if available.
Select correct authentication type and password.
Login to the web‐based configuration interface with default IP 192.168.1.1
Select your country or region's regulation.
Change device mode to Repeater from system properties.
Select wireless mode you would like to associate with.
Select channel/frequency you would like to associate with.
Use site survey to scan nearby Access Point and select the certain AP you would like
to connect with or enter SSID manually.
Select correct authentication type and password the same as Access Point.
Enable Prefer BSSID for automatically reconnected.
Select wireless mode you would like to associate with.
Use site survey to scan nearby Access Point and select the certain AP you would like
to connect with or enter SSID manually.
Configure VLAN ID in your wireless device if available.
42