Table of Contents
Advertisement
Remote Control for Daisychained Multiplexers
If you are using a computer to control two or more daisy-chained
multiplexers, you need to send a re-address command to select the
multiplexer to control. (Up to 16 multiplexers can be daisy-chained.)
Re-address commands are not printable characters; you need an 8-bit
binary address or hex value to select which daisy-chained multiplexer
you control. If you lose power to one or more multiplexers, you will need
to use the re-address command again to select the correct multiplexer.
HEX
RESULTS
00
NUL (changes active multiplexer)
01
1 (1st connected multiplexer)
02
2 (2nd connected multiplexer)
03
3 (3rd connected multiplexer)
04
4 (4th connected multiplexer)
05
5 (5th connected multiplexer)
06
6 (6th connected multiplexer)
07
7 (7th connected multiplexer)
08
8 (8th connected multiplexer)
Appendix C
Remote Control
< Table 1 > Re-Address Commands
74
HEX
RESULTS
09
9 (9th connected multiplexer)
0A
10 (10th connected multiplexer)
0B
11 (11th connected multiplexer)
0C
12 (12th connected multiplexer)
0D
13 (13th connected multiplexer)
0E
14 (14th connected multiplexer)
0F
15 (15th connected multiplexer)
10
16 (16th connected multiplexer)
Advertisement
Table of Contents
