VCR System Setup
The VCR System Setup screen is used to synchronize the
with your VCR.
NOTE : If your VCR has a synchronizing trigger pulse, using it will save
you a lot of time when setting up your system.
• VCR Input :
There is the BNC for multiplexer input from the VCR.
• External Trigger :
synchronizing trigger pulse. When using your VCR's synchronizing
trigger pulse, set to match the VCR's signal; + for positive edge
sensing and – for negative edge sensing.
• Panic Rec Buzzer :
seconds.
• VCR Type :
Selecting this brings up a list of VCRs. Select your VCR
from the list. If your VCR is not on the list select User Define.
< Figure 33 > VCR System Setup screen.
Set to Off if you are not using the VCR's
When On, the buzzer will beep every 20
41
multiplexer