Table of Contents
Advertisement
Motion Detection Schedule Setup
< Figure 28 > Motion Detection Schedule Setup schedule.
The
multiplexer
can be set up to detect or ignore motion based on a
schedule. For example, you would expect lots of activity during normal
office hours and do not want to detect motion. However, when the office
is closed, motion should generate an alarm condition.
• Timer 1 & 2 :
Each timer can be turned On or Off, and they can be set
to Mode 1 or 2. (Modes 1 and 2 are defined in the Motion Detection
Sensor Setup screen.)
• Start & Stop :
You can set the start and stop time for each timer. A
start time of 18:00 with an end time of 06:00 will go from 6:00 p.m.
until 6:00 a.m. of the following morning.
• Days :
The timers can be turned On or Off for each day of the week.
= On and
O
= Off.
• Exit :
Saves your changes and returns to the previous menu.
35
Advertisement
Table of Contents
