Table of Contents
Advertisement
DIS Digital Conference System
The CU 6105 is connected to the Conference
6.3.4
Connecting an audio recorder
Units using EC 6001-xx Cat5e cables.
This configuration is used when 'Floor' audio or
audio from one or more microphones is required
to be recorded.
Figure 6.3-E
Connecting the DCS 6000 Digital Conference System to an audio recorder.
The CU 6105 is connected to the Conference
6.3.5
Connecting an audio mixer
Units using EC 6001-xx Cat5e cables.
This configuration is used when the volume from
one or more microphones is required to be
controlled separately or equalization is needed.
One or more Outputs are connected to the
external
mixer,
where
equalization is done.
The audio from the audio mixer is then send
back to the CU using the 'Audio In 1 or 2' input.
Figure 6.3-F
Connecting the DCS 6000 Digital Conference System to an audio mixer.
20
the
control
or
User Manual CU 6105 rev C.docx
Use the 'Group' selection for the four outputs
and select the seats for each group. Refer to
section 'Please refer to section '6.5 Web Browser
Setup and Control' item #8 for more information.
Use the 'Group' selection for the four outputs
and make seat selection for each group. Refer to
section ''6.5 Web Browser Setup and Control''
item #8.
Important: If 'Out A' is also send to the mixer the following
settings must to be done:
'CU 6105 Setup * Audio * Loudspeaker Control *
Microphone -> Loudspeaker' shall be set to 'Off'.
'In 1 or 2 -> Out. A' shall be un-selected in the selection 'CU
6105 Setup * Audio * Input/Output Control * Audio In 1 or
2'.
User Manual
Advertisement
Table of Contents
