Controls And Indicators - MULTIQUIP GA-2.5H Operating And Parts Manual

120V Output Receptacle – This NEMA L5- 20R twist-
1.
lock receptacle will provide 120V, 20 amps, 60 Hz.
Applies to units with S/N 5496763 and above.
2. GFCI Receptacle – This 5-20R duplex receptacle will
provide 120V at all times.
3. AC-Voltmeter – This voltmeter indicates (with a mark)
the rated 60 Hz, single phase output voltage. In addition
the voltmeter can also be used as a diagnostic tool. If the
voltmeter indicator (needle) is below the rated voltage,
engine problems may exist (low/high RPM's). To prevent
damage to the generator or power tools turn the generator
OFF and consult your authorized MQ service dealer.
4. Ciruit Breaker – To protect the generator from an
overload, a 2- pole 20 amp circuit breaker is provided on
the control box. Make sure to place the circuit breaker to
the "OFF" postion prior to starting the engine.
5. GFCI Ground – This ground connection point should
be connect to a good earth ground (ground rod). Applies
to units with S/N 5496762 and below.
PAGE 16 — GA-2.5H A.C. GENERATOR — OPERATION & PARTS MANUAL — REV. #4 (10/07/05)
GA-2.5H — CONTROLS AND INDICATORS
Figure 2A. Generator Components
6.
7.
level ground. Placing the generator on level ground will ensure
that the low oil sensor will function properly.
ON-OFF Switch – place engine ON/OFF switch in the
"ON" position for normal operation. To turn- off the
generator place switch in the "OFF" position.
Chassis Ground – This ground connection point should
be connect to a good earth ground (ground rod). Applies
to units with S/N 5496763 and above.
This HONDA engine is equipped
with a low oil shutdown
capability. A built in sensor will
NOTE
automatically turn off the engine
should the oil level fall below a
safe operating condition. Make
sure the generator is placed on