Controlling General Audio - Kenwood DNX7230BT Instruction Manual

Return to the Top page
Controlling Audio

Controlling General Audio

1
Touch [Audio Control].
2
Set each item as follows.
Fader #/Balance #
Adjust the volume balance around the
touched area.
[2] and [3] adjust the right and left volume
balance.
[5] and [∞] adjust the front and rear volume
balance.
Volume Offset*
Finely adjust the volume of the current source
to minimize the difference in volume between
different sources.
94 94
Subwoofer Level
Adjusts the subwoofer volume. This setting is
not available when subwoofer is set to "None".
See Speaker setup (P.91).
Bass Boost
Sets the amount of bass boost among "OFF"/
"Level1"/ "Level2"/ "Level3".
Loudness
Turns the loudness control function on or
off. If turned on, high and low tones are
automatically enhanced during low volume.
Settable only when zone function (P.97) is set
to off.
* I f you have increased the volume first, then
reduced the volume using the "Volume
Offset", the sound generated if you
suddenly switch to another source may be
extremely loud.