Miele CS 1327 Operating And Installation Instructions page 17

Follow the manufacturer's instructions
when using a stainless steel cleaning
agent.
Frying surface
Use a spatula to remove any large
particles immediately.
Allow the appliance to cool down until it
can be touched by hand, and then use
a solution of hot water and washing-up
liquid to soften the soiling. Clean the
surface with the pad of a non-scouring
sponge and a few drops Miele Ceramic
and stainless steel hob cleaning agent
(see "Optional accessories"). Finally
wipe with a damp cloth and dry
thoroughly.
Ensure that every trace of cleaning
agent has been removed from the
surface by wiping carefully with a
damp cloth. Any remaining traces
could affect food the next time you
use the appliance.
Important - Conditioning agents for
stainless steel must not be used on
the frying surface.
Cleaning and care
Stainless steel frame / control panel
Clean the frame and the control panel
with a few drops of Miele Ceramic and
stainless steel hob cleaning agent (see
"Optional accessories") and a soft,
damp cloth.
Printing (settings around the control
knob)
Do not use the ceramic and
stainless steel hob cleaning agent
on the printing as it would rub it off.
These areas should be only cleaned
with an E-Cloth or with a solution of
warm water and a little washing-up
liquid applied with a soft sponge.
Control knobs
Clean the control knobs with a solution
of warm water and a little washing-up
liquid applied with a soft sponge.
Stubborn soiling should be soaked first.
Finally dry all parts with a clean cloth.
17