Lantronix SecureLinx User Manual page 90

The Remote Only method attempts authentication only with the TACACS+ server
and if unsuccessful, access is denied.
Note: With the Remote Only method, if authentication fails due to a
communication failure with the TACACS+ server automatic authentication
fallback will occur to authenticate with the local user data base on the SLP
device.
To set the authentication order:
At the SLP: prompt, type set authorder, followed by remotelocal or remoteonly and
press Enter.
Note: Lantronix recommends NOT setting the authentication order to
Remote Only until the TACACS+ has been fully configured and tested.
Displaying TACACS+ configuration information:
The Show TACACS command displays TACACS+ configuration information.
To display the TACACS configuration information:
At the SLP: prompt, type show tacacs and press Enter.
Example
The following command displays the TACACS configuration information:
SLP: show tacacs<Enter>
TACACS+ Configuration
Configuring TACACS+ Privilege Levels
Setting TACACS+ account access level privileges:
The Set TacPriv Access command sets the access level privileges for a TACACS+
account. The SLP has four defined access privilege levels; Admin, User, On-Only
and View-Only. For more information on user access levels, see
level privileges
To set the access level privilege for a TACACS+ account :
At the SLP: prompt, type set tacpriv access, followed by admin, user, ononly or
viewonly, optionally followed by a TACACS+ account number and press Enter.
Examples
The following command sets the TACACS+ account access level for account 14 to
Admin:
SecureLinx SLP Remote Power Manager
TACACS+: Enabled
Host 1: 98.76.54.32
Host 2: tacacs.lantronix.com
Port: 50
TACACS+ Key: (Set)
Auth Order: Remote->Local
on page 43.
4: Advanced Operations
Setting user access
89