Monitor System; Controls; Clear Button; Input Bays: Vcs/Channel Mode/Global Mode - SoundCraft Si Series User Manual

The monitors system encompass the following four sub-systems:
Soloing
Audio Monitors
Talkback

CONTROLS

There are three volume controls for Talkback, Monitor and Headphones, each has its own ON button.
Whenever one or more SOLO buttons is active the CLEAR SOLO button illuminates. Pressing this will clear
all the active solos on all layers.
Other control functions are accessed via the touchscreen. These are discussed in the text where appropri-

CLEAR BUTTON

ate.
The CLEAR button is used to reset a large range of parameters to default conditions. The lists are shown
below.

Input bays: VCS/CHANNEL MODE/GLOBAL MODE

This uses interrogate/clear mode, i.e. press and hold one of the VCS/CM/GM buttons in the three lists be-
low, all of the input channels, in that bay and selected bank, which have the selected parameter set will be
revealed by illuminating their SEL buttons. Pressing the CLEAR button will result in the described action.
VCS Buttons
48v
Phase
Delay
Filters
Gate In
Comp In
EQ In
LR
C
LCR
Isolate
Soundcraft® Si Series User Guide
Action
Switches 48v button selections OFF for all channels
Switches PHASE button selections OFF for all channels
Switches DELAY button selections OFF for all channels
Switches FILTER button selections OFF for all channels
Switches GATE IN button selections OFF for all channels
Switches COMP IN button selections OFF for all channels
Switches EQ button selections OFF for all channels
Switches LR button selections OFF for all channels
Switches C button selections OFF for all channels
Switches all LCR button selections OFF for all channels
Switches ISOLATE button selections OFF for all channels

MONITOR SYSTEM

Page 5 - 1