Table of Contents
Advertisement
CHAnnEL FunCtIOn ButtOns
Pressing any of the following Function buttons whilst an input Channel has it SEL button lit will activate the
function for the selected channel. It does not matter if the input bay is in Channel Mode or Global Mode.
These Function buttons are as follows.
48V
PHASE
DELAY
FILTERS
GATE IN
COMP IN
EQ IN
INSERT IN
LR
C
LCR
ISOLATE
INFO
Note that these function buttons can be used even if the input bay is in Global Mode.
IntERROGAtE MODE
Press and hold any one of the Channel Function buttons to enable interrogate mode.
In this mode the Input Channel SEL buttons will illuminate to show which channels have the selected func-
tion active (e.g. Phantom Power). Additional SEL buttons may be pressed at this time to toggle the function
in question.
Release the held Channel Function button to exit this mode.
Page 3 - 10
Switches 48v Phantom Power On/Off. (for Mic inputs only)
Switches Phase Reverse In/Out.
Switches Channel Delay In/Out.
Switches High and Low Pass filters In/Out.
Switches Gate In/Out.
Switches Compressor In/Out.
Switches Equaliser section In/Out.
Switches an Insert Point in/out, provided that an insert point has already
been patched to the channel in question.
Routes the channel signal to the Mix L & R buses via a Pan control.
Routes the channel signal to the Mix C bus.
Note that LR and C can be selected separately or together. Neither can
be used with LCR.
Routes the channel signal to the Mix L, C and R busses via Pan and
Width controls. The Pan/Width laws give constant power across the 3 bus
outputs.
LCR cannot be selected with LR or with C.
Isolates the channel from automation recall.
Changes the lower OLED display between Channel/Bus name and input/
output patch point.
Note: has no effect on the audio.
Note: Is linked to Centre (& RH on Si3) INFO swicthes
Soundcraft® Si Series User Guide
Advertisement
Table of Contents
