Table of Contents
Advertisement
Set the desired engine speed with the throttle. Allow
the engine to run at a moderate speed, "half throttle"
for 3-5 minutes before loading it too heavily. USE
FULL THROTTLE WHEN MOWING (no choke).
WARNING!
Engine exhaust and certain vehicle
components contain or emit
chemicals considered to cause
cancer, birth defects or other
reproductive system damage. The
engine exhaust contains carbon
monoxide, which is a odorless,
colorless, poisonous gas. Do not use
the machine in enclosed spaces.
Weak Battery
WARNING!
Lead-acid batteries generate
explosive gases. Keep sparks, fl ame
and smoking materials away from
batteries. Always wear eye protection
when around batteries.
IMPORTANT INFORMATION
Your mower is equipped with a 12-volt
negative grounded system. The other vehicle
must also be a 12-volt negative grounded
system. Do not use your mower to start other
vehicles.
If your battery is too weak to start the engine, it should
be recharged. (See "Battery" in the Maintenance
Section.)
If "jumper cables" are used for emergency starting,
follow this procedure:
Jumper Cables
•
Connect each end of the RED cable to the
POSITIVE (+) terminal on each battery, taking care
not to short against chassis.
•
Connect one end of the BLACK cable to the
NEGATIVE (-) terminal of the fully charged battery.
•
Connect the other end of the BLACK cable to a
good CHASSIS GROUND on the mower with the
discharged battery, away from the fuel tank and
battery.
To remove cables, reverse order
•
Remove BLACK cable fi rst from chassis and then
from the fully charged battery.
•
Remove RED cable last from both batteries.
OPERATION
Set the engine speed
Jumper cable connection
IMPORTANT INFORMATION
Leaving the ignition switch in any other
position than "OFF" will cause the battery
to be discharged and the hour meter to
accumulate hours.
8011-642
29
Husqvarna-
Advertisement
Table of Contents
