Storage - Honda FL5540K0 Operator's Manual

STORAGE

OF
END SEASON
If loader is to be dismounted from the
1.
tractor during storage, make sure parking
area is on hard, level ground.
Store in a dry, sheltered area, if possible.
2.
All hydraulic cylinders should be in the
Note:
retracted position.
Thoroughly clean the loader of all
3.
accumulated dirt and grease.
Completely lubricate the loader as
4.
specified in lubrication section of manual.
Using an oil soaked cloth, lubricate all
5.
hydraulic cylinder rods to protect them
from rust and corrosion.
Repaint any areas where paint is worn or
6.
damaged.
Wear areas on buckets or other
7.
attachmentsshould be coated with grease
to prevent rust or corrosion.
Replace any safety or warning labels that
8.
are not readable due to wear or damage.
not allow children to
-Do
on or around tractor or loader.
the
PROCEDURES
BEGINNING OF
1. Review safety precautions and operation
sections of manual.
2. Thoroughly clean loader of all
accumulated dirt and grease.
3. If removed from tractor for storage,
remount loader per
section of this manual.
Completely lubricate the loader per the
4.
lubrication section of this manual. Make
sure all fittings are taking grease properly.
5. Clean with solvent any exposed surfaces
which had been coated with grease. Wipe
dry with a clean cloth, then lubricate with
an oil soaked cloth.
6. Tighten any bolts that may have been
loosened and make sure all pins are in
place.
7. Start tractor and operate loader to make
sure it is operating properly and
are properly connected.
Check hydraulic fluid level in loader mast
8.
and fill if required. Use oil recommended
in this manual.
9. Make sure, hydraulic hoses, lines and
play
fittings are in good shape and are not
leaking. Repair or replace as, needed.
STORAGE
SEASON
"Loader
Installation"
all hoses
35