Table of Contents
Advertisement
FRONT LOADER ASSEMBLY
BUCKET AlTACHlNG
Using the bottom holes on the bucket,
10.
attach both sides of bucket to loader
frame. Use two each
clip pins.
Attach both cylinders to top holes on
bucket. Use two each
and clip pins.
The loader is now ready for hydraulic fluid.
HYDRAULIC FLUID SERVICING
You will need 6 1/2 quarts of a good grade
hydraulic fluid or ATF automatic transmission
fluid.
Remove filler plug and oil
11.
back of left mast. Fill with 4 quarts.of
hydraulic fluid.
.
Start tractor engine and set speed at
throttle. Engage tractor front PTO and
operate loader lift and bucket cylinders at
least five or six times to purge the system
of air. Lower the loader to the ground.
Retract bucket cylinders by pulling back
"B.
on handle
Add
1 /2 more quarts of hydraulic fluid or
2
until oil runs out of check hole. Replace oil
fill plug and oil check screw.
NOTE:
When lowering loader, DO NOT push
loader handle "A" all the way forward into
FLOAT.
22
inch pins and
x
3
3/4
x
inch pins
3
check screw
on
1/2
314
x 3111
PINS
VALVE HANDLES
I'
Advertisement
Table of Contents
