Operational Checks - Honda FL5540K0 Operator's Manual

Front loader for honda h5518a4 multi-purpose tractor
Table of Contents

Advertisement

OPERATIONAL CHECK
Check all pivot points on the loader.
Lubricate as necessary.
(See lubrication chart.) on page number
Check loader hydraulic fluid.
Note: Check fluid level with loader arms
down and bucket flat on the ground.
Remove oil check screw and see if oil will run
out hole. (Do not overfill)
If oil level is low, remove oil
hydraulic fluid until it runs out of oil check hole.
Re-install and tighten the oil check screw and
oil fill plug. Operate the loader up and down
several times and recheck oil level.
Replenish as necessary.
Operate and check the loader main frame and
bucket for interference, noise, and bending of
parts.
check:
Tractor Owner's Manual for recommended
That all bolts and hoses have been tight-
ened and that all tools have been removed
from tractor and loader.
Counterweights are Installed and correct.
START
UP
PROCEDURE
Ensure tractor meets all requirements in
Tractor Preparation Section.
Check front loader hydraulic fluid level. Refer
to front loader operator's manual.
44
fill plug and add
using loader, double
Note: Bucket and lift cylinders should be fully
retracted when checking hydraulic fluid level:
Check all hydraulic hose connections to
ensure that they are not leaking.
Lubricate all pivot points that incorporate
grease fittings.
Start tractor and run engine at approximately
-
1400 RPM
for initial cycling of loader.
1200
Push PTO lever forward to "ON"
-Before using front loader for
the first time, cycle
lift
purge air from cylinder.
system can cause unexpected fall
frame, causing Injury or damage to loader or
tractor.
Cycle lift and bucket cylinders with bucket
empty several times to seat-in cylinder
components.
Check all hydraulic hose routings to ensure
adequate clearances exist between hoses
and adjacent components.
1 -
-The tractorlfront loader
should only be operated with all safety
equipment properly Installed.
-Operate loader from
,tractor seat only. Engine will not run with
engaged unless operator's seat
OPERATIONAL
CHECK
and bucket cylinders to
the hydraulic
Air in
main
of
the
occupied.
25

Advertisement

Table of Contents
loading

Table of Contents