Snmp User Table - D-Link DES-3010F Manual

The DES-3018 supports the Simple Network Management Protocol (SNMP) versions 1, 2c, and 3. The administrator can
specify the SNMP version used to monitor and control the Switch. The three versions of SNMP vary in the level of
security provided between the management station and the network device.
SNMP settings are configured using the menus located on the SNMP V3 folder of the web manager. Workstations on the
network that are allowed SNMP privileged access to the Switch can be restricted with the Management Station IP Address
menu.

SNMP User Table

The SNMP User Table displays all of the SNMP User's currently configured on the Switch.
In the SNMP Manager folder, located in the Administration folder, click on the SNMP User Table link. This will open
the SNMP User Table, as shown below.
To delete an existing SNMP User Table entry, click the
wish to delete.
To display the detailed entry for a given user, click on the hyperlinked User Name. This will open the SNMP User Table
Display page, as shown below.
The following parameters are displayed:
Parameter
User Name
Group Name
SNMP Version
DES-3010F/G / DES-3018 / DES-3026 Fast Ethernet Switch Manual
Figure 6- 15. SNMP User Table
Figure 6- 16. SNMP User Table Display
Description
An alphanumeric string of up to 32 characters. This is used to identify the SNMP
users.
This name is used to specify the SNMP group created can request SNMP messages.
V1 - Indicates that SNMP version 1 is in use.
V2 - Indicates that SNMP version 2 is in use.
V3 - Indicates that SNMP version 3 is in use.
below the Delete heading corresponding to the entry you
53