Time Zone and DST
The following are screens used to configure time zones and Daylight Savings time settings for SNTP. Open the
Administration folder, then the SNTP folder and click on the Time Zone and DST link, revealing the following screen.
The following parameters can be set:
Parameter
Daylight Saving
Time State
Daylight Saving
Time Offset in
Minutes
Time Zone Offset
from GMT in +/-
HH:MM
Using repeating mode will enable DST seasonal time adjustment. Repeating mode requires that the DST
beginning and ending date be specified using a formula. For example, specify to begin DST on Saturday during
the second week of April and end DST on Sunday during the last week of October.
From: Which Day
From: Day of Week
DES-3010F/G / DES-3018 / DES-3026 Fast Ethernet Switch Manual
Figure 6- 12. Time Zone and DST Settings page
Description
Use this pull-down menu to enable DST Repeating Settings (Repeating) or DST Annual
Settings (Annual). Selecting one of these will allow its corresponding field to be
configured.
Use this pull-down menu to specify the amount of time that will constitute your local DST
offset - 30, 60, 90, or 120 minutes.
Use these pull-down menus to specify your local time zone's offset from Greenwich
Mean Time (GMT.)
DST Repeating Settings
Enter the week of the month that DST will start.
Enter the day of the week that DST will start on.
Time Zone and DST
49