Setting The Bass Control; Sound Setting - Alpine CDE-102 Quick Reference Manual

Sound Setting Setting the Bass Control
Setting the Bas. Center Frequency
2-1 Press BAND to select the desired bass center
frequency.
80 Hz -t 100 Hz -t 200 Hz ~ 60 Hz ~ 80 Hz
Emphasizes the displayed bass frequency ranges.
You can change the Bass Frequency emphasis
10
create your own lonal
preference.
1
Press SOUND/SETUP repeatedly to select the
BASS mode.
BASS ~ TREBLE ~ HPF -t BASS
~/ESC
SOUNDISETUP
BAND
I
0 CJ
_u
II[[ID
/I
IfI
I)~ II
DOI.l .,
i\ \~
J"'?'(
. .
..
.~(@
I
SOURCEI<!> Rotary encoder (AUDIO/LOUD)
Adjusting Subwoofer level/Bass level/
Treble level/Balance (Between left and
Right)/Fader (Between Front and Rear)/
Defeat
2-2 Press SOURCE/<!> to select the desired bass
bandwidth.
1
Press Rotary encoder (AUDIO) repeatedly to
choose the desired mode.
Each press changes the mode as follows:
SUBWOOFER* -t BASS LEVEL -t TRE LEVEL -t BALANCE
~
FADER -t DEFEAT
~
VOLUME
~
SUBWOOFER
Changes the boosted bass bandwidth to wide or narrow. A
wider setting will boost a wide range of frequencies above
and below the center frequency. A narrower setting will
boost only frequencies near the center frequency.
Subwoofer . +0 - + 15
Bass level: -7 - +7
Treble level: -7 - +7
Balance: L15 - R15
Fader: R15 - F15
Defeat: ON/OFF
Volume: 0 - 35
• Ifllo operatioll is pe/formedfor
5
secollds ajier selecting the
SUB WOOFER, BASS LEVEL TRE LEVEL. BALANCE. FADER or
DEFEAT mode. the llllit automatically returns to lIormal lllOde.
. ~ettirigth~B~ss Le",~1
2-3*tTurn the Rotary encoder to select the desired
bass level (-7-+7).
You can emphasize or weaken the bass level.
3
Press and hold
~/ESC
for at least 2 seconds to
return to normal mode.
*
Whell the .Hlbwoo/er mode is .'et to OFF. its level call1lol be adjusted.
2 Turn the Rotary encoder until the desired sound is
obtained in each mode.
By setting DEFEAT ON. previously adjusted settings of
BASS LEVEL and TRE LEVEL will return to the factory
defaults.
• Ifno operation is petjoJ7netl/(Jr 15 seconds. the ullit will relul'll to
lIormal mode automatically.
• The bass le\'el settings will be individually memori:ed/(Jr each
source (FM, AM, CD. elc.) ulltil the selling is challged. The bass
frequency and bass bandwidth settings adjustedjor olle source are
effective jor all other sourees (FM. AM. CD. etc.).
• ThefunClioll is inoperable when DEFEAT is set to ON.
*1
The adjustmelll can also be made by pressing Rotary encoder.
Refer
10
"Adjusting Sub woofer Le\'eIIBass Lel'el/freble Levell
Balance (Between Leji and Righl)/Fader (Between Fmnt and Rear)!
Defeat" (page 12).
12-EN