Figure 1.
Installing The Memory
1.
Align the notch on the memory-card with the tab in the system-board connector.
2.
Insert the memory module into the memory socket.
3.
Press down on the memory module until the securing clips secure the memory in place.
4.
Install the cover.
5.
Follow the procedures in
Removing The Heatsink
1.
Follow the procedures in
2.
Remove the:
– cover
– bezel
3.
Follow the steps below to remove the processor heat sink:
a) Disconnect the heatsink and fan assembly cable from the system board.
b) Loosen the captive-screws that secure the heatsink and fan assembly to the system board.
c) Lift the heatsink and fan assembly upward and remove it from the computer.
After Working Inside Your Computer .
Before Working Inside Your Computer .
15