Table of Contents
Advertisement
Installing the memory
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the memory modules and provides a visual representation of the installation
procedure.
Steps
1. Ensure that the securing clips are in an open position.
2. Align the notch on the memory module with the tab on the memory-module slot.
3. Press down on the memory module until the memory module snaps into position and the securing clip locks in place.
CAUTION:
To prevent damage to the memory module, hold the memory module by the edges. Do not touch
the components on the memory module.
NOTE:
Repeat step 1 to step 3 to install more than one memory module in your computer.
Next steps
1. Install the
disk-drive
cage.
2. Install the
3.5-inch hard drive
3. Install the
2.5-inch hard drive
4. Install the
front
bezel.
5. Install the
side
cover.
6. Follow the procedure in
if applicable.
if applicable.
After working inside your
computer.
Removing and installing Customer Replaceable Units (CRUs)
55
Advertisement
Table of Contents
