Connecting The Terminals - Kenwood VR-6050 Instruction Manual

Setting up the system
Comecting the tmninals
0 Strip coating.
0 Loosen.
- I
Q Insert. ,,
0 Secure.
r
0 Strip coating.
0 Push the lever.
0 Insert the cord.
0 Return the lever.
Connection
of banana plugs (For the U.S.A. and Canada)
0 Secure. 0 Insert.
y$
55
-\
/PC '
/'
l
Soutrd will tnot be heard If tire speaker terminal IS not fully secured
l
New short crrcut the + at?d - speaker cords
l
If the left and rrght speakers are connected Inversely or the speaker
cords are connected with reversed polarrty, the sound wrll be
unt?atiltalwlthamblguousacoustlc~~nag~ng Besuretoconnectthe
speakers correctly
Speakerimpedance
After confirming the speaker Impedance rndrcat~ons printed on the
rear panel of the receiver, connect speakers wrth matchrng Imped-
ance iatrngs. Usrng speakers with a rated impedance other than that
Indicated 01, the rear panel of the receiver could result rn malfunctrons
or damage to the speakers 01 receiver
Speaker placement
Center srxaker
\
Front speakers Place at the front left and right of the lrstenrng
posItIon Front speakers are required for all surround modes.
Center speaker Place front and center Thus speaker stabrlrzes the
sound Image and helps recreate sound motion Required for surround
playback
Surround speakers
Place at the direct left and right, or slrghtly
behind, the listenrng posrtron at even heights, approxrmately 1 meter
above the ears of the listeners These speakers recreate sound
tnotron and atmosphere. Required for surround playback.
Subwoofer Reproduces powerful deep bass sounds.
Surround backspeaker
Place the speaker directly at the rear of the
Ilstenrng posrtion The optrmum posrtron depends mainly on the room
cor?ditron
l
Although the Ideal surround system consrsts of all the speakers
lrsted above, if you don't have a center speaker or a subwoofer. you
can drvide those signals between the available speakers rn the
speaker settngs steps to obtain the best possrble surround repro-
ductron from the speakers you have available
-@z
Channel space switching
Except for the U.S.A., Canada, U.K., and Australia)
The space between radro channels has been set to the one that
prevails in the area to whrch the system IS shopped. However, If the
current channel space settrng does not match the settrng tn the area
where the system IS to be used, for instance when you move from
area 1 or area 2 shown in the followrng table or vrce versa, proper
reception of AM/FM broadcasts cannot be expected. In thus case,
change the channel space setting rn accordance with your area by
referring to the followrng table
Turn the power OFF by presstng the POWER key before movrng the
switch level Move swatch lever to match your area wrth a small
screwdrlver or other pornted tool, then turn the power on again
15EN