Remote Commands - Radio Shack TAD-734 Owner's Manual

43-734.fm Page 29 Thursday, February 24, 2000 10:42 AM
• When the TAD is in remote opera-
tion, it stops all answering func-
tions and the display on the base
shows rC . The TAD resumes
answering functions when it is no
longer in remote command if you
have not turned it off.
• The remote playback of incoming
messages is limited to 4 minutes.
If you have more messages after
4 minutes have passed, you must
press again to listen to the rest
# 2
of the messages.
• When using remote operation,
you can only delete the current
message during playback. You
cannot delete all the messages
stored at one time.
• The maximum length of a memo
recorded by remote operation is 4
minutes.
3. To use a remote command, press
and (within 2 seconds) the number
for the command you want.

Remote Commands

Press
# then:
1 Repeat current message dur-
ing playback (after 3 seconds
of playback).
1 Repeat the previous mes-
sage. (You must press 1
before 3 seconds of the cur-
rent message is played back.)
2 Play messages.
3 Skip current message during
playback.
4 Delete current message dur-
ing playback.
5 Stop playback, recording, and
room monitoring.
6 Set the TAD to answer calls.
#
7 Record a memo or stop
recording a memo.
8 Record or stop recording a
new outgoing message.
9 Set the TAD to not answer
calls.
Monitor the room where the
TAD is located for 15 seconds.
Note: The remote operation stops when
someone picks up the handset or any
phone on the same phone line.
To:
29