Deleting Messages; Recording A Memo; Changing The Remote Operation Security Code - Radio Shack TAD-1028 Owner's Manual

43-788.fm Page 19 Monday, August 16, 1999 8:19 AM

DELETING MESSAGES

To delete all the messages you have al-
ready played, while
stopped, hold down
. The TAD-1028 sounds a long
LETE
beep then deletes all old messages, but
keeps any new messages (and the
PLAY/SKIP indicator continues flash-
ing).
Notes:
• Even if you have played only a
small portion of a message, the
TAD-1028 might delete it.
• Individual messages can only be
deleted by remote operation (see
"Remote Operation" on Page 21).

RECORDING A MEMO

A memo is a message you can record at
the TAD-1028, without having to call in
on a phone.
Notes:
• The maximum memo length is 60
seconds.
• When memory is full, the TAD-
1028 announces, "Memory is full,"
and you cannot record the memo.
Delete old messages to make
room in memory (see "Deleting
Messages" on Page 19).
playback is
ANSWER/STOP/DE-
Follow these steps to record a memo.
1. Hold down PLAY/SKIP
TAD-1028 beeps.
2. Speak in a normal voice into the
microphone on the front of the
TAD.
3. The TAD-1028 automatically stops
recording after 60 seconds, or you
can press
ANSWER/STOP/DELETE
when you finish the memo. The
TAD-1028 beeps once.
The memo is recorded along with the in-
coming messages. To hear the memo,
simply play back your messages.
CHANGING THE REMOTE
OPERATION SECURITY
CODE
The TAD's remote operation security
code is preset to 788. You can operate
your TAD-1028 remotely with this code;
however, we recommend that you set
your own code.
Notes:
• Be sure to set each digit within 8
seconds. Otherwise, you must start
over from Step 1.
• If AC power fails and the backup
battery becomes weak, the remote
operation security code automati-
cally resets to 788.
until the
19