Remote Operation; Using The Toll-Saver; Using Remote Commands - Radio Shack TAD-734 Owner's Manual

900 mhz cordless speakerphone digital answering system with caller id
Hide thumbs Also See for TAD-734:
Table of Contents

Advertisement

43-734.fm Page 28 Thursday, February 24, 2000 10:42 AM
To check your PIN at any time, press
. The PIN appears in the message
PIN
counter window, and the TAD announc-
es it.
Note: If you press
SPEAKER
while changing the PIN, the TAD
STOP
exits. Begin again with Step 1.

REMOTE OPERATION

While you are away from your home or
office, you can use a touch-tone phone,
or a pulse (rotary) phone with a pocket
tone dialer (available through your local
RadioShack store) to enter your PIN and
do any of the following:
• Set the TAD to answer or not
answer calls.
• Listen to your messages.
• Record a new outgoing message.
• Record a memo.
• Delete messages.
• Monitor the room where the TAD is
located.
Note: You cannot remotely operate the
TAD-734 using its handset or another
telephone on the same line as the TAD.

USING THE TOLL-SAVER

If
is set to
RING TIME
(see "Setting the Number of Rings" on
Page 12), the TAD-734 answers after
three rings if you have new messages
(ones you have not listened to). If there
28
are no new messages, the TAD answers
after five rings. This gives you time to
hang up before the TAD answers so you
can avoid unnecessary long-distance
charges.
or
PLAY/
USING REMOTE
COMMANDS
Follow these steps to operate the TAD
from a remote location.
Note: If you wait more than 15 seconds
between
sounds a long beep and hangs up.
1. Dial your phone number and wait for
2. When the outgoing message begins
(toll-saver),
T/S
each
keypress,
the TAD to answer.
If the TAD is not set to answer calls,
it will answer after about 10 rings
and sound a series of beeps.
(or the TAD sounds a series of
beeps), press
, then enter your PIN
#
within 2 seconds.
If the PIN is correct, the TAD
announces the day and time, then it
announces the number of new and
old messages. The TAD plays all
new messages then beeps about
once every two seconds to let you
know it is ready to accept remote
commands.
Notes:
• If the TAD does not respond, try
entering your PIN again. If you
enter an incorrect PIN three
times, the TAD beeps and hangs
up.
the
TAD

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

43-734

Table of Contents