Adjusting The Tad'svolume; Deleting Messages; Setting The Remote Operation Pin - Radio Shack TAD-734 Owner's Manual

43-734.fm Page 27 Thursday, February 24, 2000 10:42 AM
To replay the current message from the
beginning, press
REPEAT
within about 2 seconds (4 sec-
REPEAT
onds during remote operation) after a
message begins playing, the TAD re-
plays the previous message.
ADJUSTING THE TAD'S
VOLUME
To adjust the speaker's volume, repeat-
edly press
VOLUME
base. The volume setting from
est) to 10 (highest) appears in the mes-
sage counter window.

DELETING MESSAGES

To delete the current message while it is
playing, press
DELETE
beeps.
To delete all messages at once, while
messages are not playing, hold down
on the base until the TAD
DELETE
beeps and appears in the message
0
counter window.
Note: You cannot delete new (un-
played) messages. If you try to delete all
messages at once while you still have
new messages, the TAD sounds five
. If you press quick beeps and does not delete any
messages.
SETTING THE REMOTE
OPERATION PIN
The TAD-734's two-digit remote opera-
tion PIN (personal identification number)
prevents unauthorized remote access to
your messages. The PIN is preset to 80.
9 8
or on the Follow these steps to change the PIN to
(low- any number from 00 to 99.
1
Note: If you wait more than 2 minutes
between each keypress, the TAD exits
the PIN setting process. Start again at
Step 1.
until the TAD
1. Hold down until the TAD beeps
PIN
and 00 appears in the message
counter window.
2. Press to set the first digit of the
SKIP
PIN higher or
REPEAT
Then press .
PIN
3. Press or
SKIP REPEAT
second digit of the PIN, then press
. The TAD announces the new
PIN
PIN.
to set it lower.
to set the
27