Radio Shack TAD-734 Owner's Manual page 31

43-734.fm Page 31 Thursday, February 24, 2000 10:42 AM
Problem
The handset stops working or
works poorly during a call.
The TAD does not answer calls.
The TAD does not record call-
ers' messages.
flashes on the
Low Battery
display every few seconds.
You have an incoming call, but
do not receive any Caller ID
information.
If you still have problems, disconnect the TAD-734. If other phones on the same line
work properly, the fault is in this phone or its installation. If you cannot find the prob-
lem, take your phone to your local RadioShack store for assistance.
Suggestion
Move the handset closer to the base.
Lift the base's antenna to a vertical position.
Be sure the battery pack is charged. (If the battery power
is too low, it does not have enough power to light the dis-
play.)
If the base loses power while the handset is away, the
security access-protection code might change. Restore
power to the base, then place the handset back on the
base. The CHARGE/IN USE indicator lights, indicating
that the code is set again.
Check the charging contacts on the handset and base. If
they are dirty, clean them with a pencil eraser.
Make sure the TAD is turned on.
Make sure the AC adapter is properly connected.
Check all phone line connections.
(
is set to
REC TIME ANN
.
or
4
Delete messages if memory is full.
Be sure the battery pack is correctly connected.
Let the phone ring twice before you answer so the sys-
tem has time to record the Caller ID information.
Check that the system is correctly and securely con-
nected.
Call your phone company to verify that your Caller ID
service is active.
announcement only). Set it to 1
31