Replacing The Processor Module; Procedure - Dell Alienware 14 Owner's Manual

Replacing the Processor Module

WARNING:
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. After working inside your computer,
follow the instructions in "After Working Inside Your Computer" on
page 11. For additional safety best practices information, see
the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.

Procedure

NOTE:
If a new processor module is installed, you will receive a new
thermal-cooling assembly, which will include an affixed thermal pad, or you
will receive a new thermal pad along with documentation to illustrate proper
installation.
1 Align the pin-1 corner of the processor module with the pin-1 corner of the ZIF socket,
then place the processor module.
NOTE: The pin-1 corner of the processor module has a triangle that aligns with
the triangle on the pin-1 corner of the ZIF socket.
When the processor module is properly seated, all four corners are aligned at the
same height. If one or more corners of the module are higher than the others,
the module is not seated properly.
CAUTION:
cam screw and the processor module when replacing the processor,
press to apply slight pressure to the center of the processor module
while turning the cam screw.
CAUTION:
screwdriver perpendicular to the processor module when turning the
cam screw.
2 Tighten the ZIF socket by turning the cam screw clockwise to secure the processor
module to the ZIF socket.
Before working inside your computer, read the safety
To prevent intermittent contact between the ZIF-socket
To avoid damage to the processor module, hold the
Replacing the Processor Module
97
|