Wohler AMP2-VSDA/AM User Manual page 16

AMP2-VSDA/AV and AMP2-VSDA/AM User Manual P/N 821576 Rev-B
General Description
All models in the AMP Series contain high performance transducers (speakers) driven by three power amplifiers; two amplifier/
driver combinations handle midrange and high frequency information in the left and right (stereo) speaker channels, while the third
amplifier channel sums the left and right channel information below the 500 Hz crossover point in the woofer (bass) speaker(s). Note
that the woofer channel is NOT a dedicated LFE (subwoofer) or Center channel.
Speaker Configuration
All AMP2 (2U) products are configured with two speaker channels (left and right) to reproduce midrange and high-range audio
frequencies (in stereo) and one woofer speaker channel to reproduce the summed (combined) low-range audio frequencies from
the left and right speaker input channels.
See below for a simplified diagram of the AMP2 audio amplifier/speaker configuration.
The balance control attenuates the signal from the source, so that the left and right bass frequencies (summed together and
reproduced in the woofer channel) will also respond to the balance control.
Example:
If an audio signal of a voice speaking English is fed to the left (A) input and a voice speaking Spanish is fed to the right
(B) input, then the left speaker channel will reproduce the midrange and high-range frequencies of the English speaking
voice, the right speaker channel will reproduce the midrange and high-range frequencies of the Spanish speaking voice,
and the woofer speaker channel will reproduce the summed (combined) low-range frequencies of both voices.
If the balance control is rotated to the left (English), then the Spanish speaking voice in the right speaker channel will
diminish in volume and the Spanish speaking voice in the woofer speaker channel will also diminish.
The converse is true if the balance control is panned to the right.
Note that if the balance control is rotated completely to the left, the volume in both the left speaker channel and woofer speaker
channel will increase slightly to maintain overall output level. See the simplified diagram below for placement of the balance control
in the audio amplifier circuit.
16
Audio Amplifier and Speaker Configuration
Balance Control Characteristics
© 2004 Wohler Technologies Inc. ALL rights reserved
Section 2: Operation