TATA Motors Indica V2 Owner's Manual & Service Book page 91

MAINTENANCE & CAR CARE
6. Wait for 3-4 seconds before next stroke.
7. Repeat until bubbles stop emanating from bleed tube.
8. Close bleed screw immediately after the last downward
stroke of pedal and hold pedal.
9. Tighten bleed screw and remove tube.
10. Replace dust cap on bleed screw.
11. Repeat same procedure on rear right, front right and then
rear left.
12. If bleeding continues without success it means air is being
drawn in past the bleed screw threads.
13. Close bleed screw at the end of each downward stroke
of pedal.
14. Allow pedal to return fully and slowly.
15. Tighten bleed screw finally after last downward stroke
of pedal .
16. Replace the dust cap on the bleed screw.
17. Apply brake pedal hard and check for any leaks.
90
Clutch & Brakes
3
2
Rear
Front
1
4