TATA Motors Indica V2 Owner's Manual & Service Book page 60

STARTING & DRIVING
Engine Coolant Level :
The coolant level is visible through the translucent reservoir. It should
be between max. & min. marks. If it seems less, add premixed coolant
into the auxiliary tank upto the max. mark. Put the cap back properly.
Never remove the filler cap when the engine is hot. Use only
branded premixed ready to use coolant.
In case of an emergency, normal water can be used, but the system
should be flushed & filled with proper coolant mixture at the earliest.
Brake Fluid Level :
The level of the brake fluid must be between the min. & max. marks on
the side of the brake fluid container. If the level falls below the min.
mark, add recommended brake fluid. (Refer chapter - Fuels, coolants &
lubricants)
In case of spongy or hard pedal or low brake efficiency, please contact
the nearest Authorised Service outlet.
1. Do not allow brake fluid to make contact with the skin or
eyes.
2. Do not allow brake fluid to splash or spill on the paint
surface as it will damage the paint. In case of spillage, wipe
it off immediately.
Engine Coolant & Brake Fluid Level
59