Door Handle Installation; Cleaning And Care; Moving Your Wine Cellar - Vinotemp VT-WC58GNV-SB10 Owner's Manual

Setting the temperature: You can manually adjust the temperature. Simply
press the DOWN arrow button on the control panel to decrease the temperature
and the UP arrow button to increase the temperature by 1 degree inside the
wine cellar. The temperature range for this unit is from 45°F (7°C) to 65°F
(18°C).
When the cabinet temperature is too low, the LED will display "LL". When the
temperature is too high, it will display "HH". The "ER" display shows when there
has been a power disruption.

DOOR HANDLE INSTALLATION

1. Gently pull away the door gasket in the area where the handle is to be
installed. The gasket is easily displaced by hand; no tools are necessary.
2. Use a Phillips head screwdriver to remove/install screws securing door handle.
(Do not over tighten screws as this will cause damage to the handle.)
3. If needed, use a flat head screwdriver to remove the 2 decorative plugs from
the front of the door or the plugs at the top of the door where the hinge is
located, if they are located on the side you wish the handle to be installed on.
Save the plugs for future use.
4. Replace the door gasket to its original position. Insert plugs into open door
holes if desired.
 Always unplug the wine cellar before cleaning.
 Do not use benzene, scrubbing brushes or chemical cleaners as these will
damage the unit.
 Use only a mild, nonabrasive cleanser to clean the exterior of the cabinet.
 Clean the stainless steel door and handle by wiping with a warm water and
baking soda solution. The solution should be about 2 tablespoons of baking
soda to a quart of water.
 Wash the racks with a mild detergent solution.
 Always dry all parts with a clean, dry cloth before plugging the wine cellar
back into the receptacle.
 Always unplug the wine cellar before moving.
 Remove all bottles before moving the wine cellar.
 Securely tape down all loose items and shelves inside your appliance.
 Turn the leveling legs up to the base to avoid damage.
 Tape the door shut.
 Be sure the wine cellar stays in the upright position during transportation
 Protect the outside of appliance with a blanket or similar item when moving
as needed.
8

CLEANING AND CARE

MOVING YOUR WINE CELLAR

W W W . V I N O T E M P . C O M
Meijer.com
8