Table of Contents
Advertisement
•
Remove the exterior and interior packaging before use.
•
Check to be sure you have all of the parts and an owner's manual.
•
Place your wine cellar on a flat, dry surface that is strong enough to support the unit when fully loaded.
•
This unit is designed for free standing installation only.
•
Do not place heavy objects on top of the unit.
•
Unit is not designed for installation in a garage, basement, or any other location where a controlled
ambient environment between 50° and 90°F cannot be maintained.
•
Do not place the unit in direct sunlight or near sources of heat. Extreme hot and cold ambient
temperatures may cause the unit not to perform properly or increase electrical consumption.
•
Do not place the unit next to a major appliance that emits large amounts of heat, such as a
dishwasher, microwave, oven, etc.
•
Do not plug unit into the same outlet as a refrigerator or microwave.
•
Before connecting the appliance to the power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
•
Clean the interior surface with lukewarm water using a soft cloth before first use.
•
The unit is designed for freestanding installation only. It is not designed to be installed under a
counter, inside a cabinet, or in any location that does not allow the proper clearances on all sides.
•
IMPORTANT: To function correctly, wine cooler needs a minimum of 10-12 inches clearance on each
side, 6 inches of clearance at the rear, and unlimited clearance at the top of the cooler.
1.
Gently place/slide the racks into the wine cellar.
2.
Determine the best temperature setting to use.
3.
Place bottles inside the cooler.
4.
Plug the power cord into a standard grounded electrical outlet.
5.
Limit the frequency of opening the door to conserve energy and maintain proper storage temperature.
6.
Turn the interior light on and off by touching the button labeled with a light on the control panel.
Important: When using the wine cellar for the first time, allow at least 24 hours for the internal temperature to
adjust properly. Make sure at least three to five bottles are in the unit.
Your wine cooler has a touch screen control panel located on the upper part of the glass door.
Setting the temperature:
You can manually adjust the temperature inside your wine cooler. Simply press the down arrow button on the
control panel to decrease the temperature and the up arrow button to increase the temperature by 1 degree
increments. The temperature range for this unit is from 39°F (4°C) to 65°F (18°C).
To switch the temperate display from showing Celsius and Fahrenheit, press the C/F button.
8
WINE CELLAR INSTALLATION
OPERATING INSTRUCTIONS
TEMPERATURE CONTROL
W W W . V I N O T E M P . C O M
Advertisement
Table of Contents
