Assembly - Pro-Form PFTL39907.0 User Manual

ASSEMBLY

To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480. Assembly
requires two persons. Set the treadmill in a cleared area and remove the packing materials; do not dispose of the
packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
high-performance lubricant. During shipping, lubricant may be transferred to the top of the walking belt or to the
shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top
of the walking belt, wipe it off with a soft cloth and mild, non-abrasive cleaner.
Assembly requires the included hex keys
mallet , adjustable wrench
To identify assembly hardware, see the drawings below. The number in parentheses below each drawing is the
key number of the part, from the PART LISTon page 24. The number following the parentheses is the quantity
used in assembly. To avoid damaging plastic parts, do not use power tools for assembly.
Handrail Bolt (20)–4
Upright Bolt/Wheel Bolt (40)–6
Frame Bolt (32)–2
1. Orient the Base (48) as shown.
Identify the Right Upright (36), which has a
square hole near the lower end.
Orient the Right Upright (36) as shown, and
attach it to the Base (48) with two Upright Bolts
(40) and two Upright Star Washers (39); do not
tighten the Upright Bolts yet.
and your own phillips screwdriver
, and wire cutters
3/4" Screw (2)–6
Silver Ground
Screw (27)–2
Console
Bolt (22)–2
1
6
.
Wheel Spacer
1/4" Star Washer
(44)–4
Handrail Star
Washer (19)–4
Frame Washer
(33)–2
Upright Star
Washer (39)–4
Nut (47)–4
36
48
Square
Hole
, rubber
(21)–2
39
40
39
40