Samsung VP-D30 Service Manual page 63

3. LCD Adjustment
Note : For LCD adjustment, use the buttons on the video camera and the SET key.
After each adjustment step is completed, OSD shows "OK".
EEPROM(ICL202) stores confirmed adjustment value of each adjustment step.
After finishing the adjustment, turn power off.
3-1 How to get into the LCD adjust mode
STEP 1
ΠConnect the power source (battery/DC cable).
´ Set the power switch to "REC" position.
ˇ Set the Lens to CAMCORDER.
¨ Camera screen and OSD appears.
ˆ Open housing of the video camera and remove tape.
Ø Open the LCD.
STEP 2
ΠPress and hold the "STOP" and "PB ZOOM" buttons on the video camera at the same time for more than
5 seconds.
´ When monitor OSD appears as shown Fig. 3-2, the adjustment mode has been activated successfully.
ˇ Move the "MENU Selector" to highlight LCD/CVF ADJ and push the "MENU Selector".
¨ When changing the adjustment item, please press the "EASY"/"DISPLAY" buttons on the camera.
ˆ You can change the adjustment value to move the "MENU Selector" Up or Down.
Ø After setting adjustment value, please push the "MENU Selector" to confirm Data.
DISPLAY Button
PB ZOOM Button
EASY Button
3-2 Function of each buttons on the SET Key
Buttons
MENU Selector push (Confirm)
EASY (Mode Up)
DISPLAY (Mode Down)
MENU Selector up (Data Up)
MENU Selector down (Data Down)
Note : In service adjustment mode, button names are different from those in customer function control mode.
Samsung Electronics
STOP Button
MENU Selector
Fig. 3-1
Stores changed value in the adjustment and auto adjustment mode.
Shift adjustment address to left.
Shift adjustment address to right.
Up value.
Down value.
VCR ADJ
CAM ADJ
CODEC ADJ
PRML ADJ
CAM DISP
DSC ADJ
LCD/CVF ADJ
<Table 3-1>
Description
Alignment and Adjustments
ADJ ITEM
Fig. 3-2
3-1