Advanced Operations; Handset Registration - EnGenius DuraFon PRO User Manual

Advanced Operations

Handset Registration

1. If your handset is purchased as part of a system, it has been pre-
registered with the base station at the factory.
2. If the Handset ID reads "00", that means it is a new handset or the ID
has been erased. You need to register the handset with the base
station. In certain situations, you may want to change a handset's ID.
For example, you want to change a particular handset from a user to an
administrator (ID 10 or 11), or vice versa. Or in some rare occasions,
you find another handset having the same Handset ID.
3. Registration:
MENU
a. Press -6 to enter the registration mode
b. Press and hold the base's Registration
until the L1, L2, L3, and L4 LED come on.
c. Press handset key
The base station will assign a handset ID between 10 and 99. The
assigned ID will be displayed on the handset LCD, indicating
successful registration.
d. Repeat above steps for all additional handsets.
e. The first two handsets registered will be given ID 10 and 11, which
gives them administrator privileges.
Re : Base "00" is a primary base. All handsets must register to
Base "00".
4. De-registration:
a. You can de-register a handset from a base. De-registration will reset
the Handset ID to 00, erase the system security code, and free up the
old ID for future registration.
b. After deregistration, the handset will not be able to use the base to
make or receive phone calls, nor can it use the intercom to reach
other handsets.
c. Press handset MENU
d. Press the handset number key
registration menu.
e. Press and hold the base's
and L4 LED come on.
REG
1 , this completes the registration process.
(Right softkey).
6 , this will enter the handset
REG button for 2 seconds until L1, L2, L3,
41
button for 2 seconds