EnGenius DuraFon PRO User Manual page 25

1. DC In
Connects to Charger AC Adaptor.
2. Handset Charging Slot
a. Charge handset battery when handset is placed in cradle.
b. Refer to the handset LCD for charging status.
i. Charging: LCD screen showed "Charging".
ii. Fully Charged: battery status bar stands still and the LCD screen
iii. Charge Fail: Should an error occur during charging mode, the
LCD screen would display "Charge Fail".
3. Spare Battery Charging Slot
a. Charge spare battery when battery is placed in slot.
B. LED as the spare battery charging indicator.
i. Slot is empty and the power is on: LED is Green light.
ii. Charging: LED is Orange light.
iii. Fully Charged: LED returns to Green light.
4. It is impossible to overcharge the battery using this charger.
5. The AC adapter can be used as a travel charger and plugged directly
into the handset's DC port (located next to the headset port).
However, you can not turn off the power while charging with
the travel charger. A Warning message: "Unplug Travel Charger then
OFF" will be shown on the LCD display.
Notes:
1. Fully charge battery packs before first use.
2. Both handset and spare batteries can be charged at the same time.
3. Handset will be "power on" automatically when placing on the
charging slot.
4. However, if you run down the battery, it will take around one
minute for handset to auto power on.
5. Removing a ringing handset from the charging cradle will auto
answer the call.
Charger Features
would display "Fully Charged".
25