Entering Setup Mode; Diagnostics Mode - NCI 7815 User Manual

Entering Setup Mode

Accessing the
Menu Mode
Figure 1
Switch Diagram

Diagnostics Mode

Diagnostic DIAG Mode
You can access the MENU Mode by pressing
switch 1 shown in Figure 1.
In the Menu Mode, there are four modes avail-
able. They are as follows:
Diagnostic Mode (DIAG) – Used to test areas of
the scale's function.
Configuration Mode (CONF) – Used to config-
ure the scale for your application.
Calibration Mode (CAL) – Used when calibrat-
ing the scale.
Recalibration Mode (RE-CAL) – Used to
change resolution and rounding-type.
The structure for these menus is shown in Figure
2. Following that are the step-by-step instructions
for accessing the items within each menu.
The diagnostic (DIAG) mode menu lets you test
specific areas of the unit's function. These areas
are:
Display (DISP) – Shows the version and revision
of the software, followed by a display segment
test.
Model 7815 Parcel Bench Scale User's Manual
9