MOON 100 D Digital-to-Analog Converter Important Safety Instructions Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block ventilation openings. Install in accordance with the manufacturer’s instructions.
Page 3
NEVER wet the inside of the MOON 100 D with any liquid. If a liquid substance does enter your MOON 100 D, immediately disconnect it from the AC mains and take it to your MOON dealer for a complete check-up.
The performance of your 100 D will continue to improve during the first 400 hours of listening. This is the result of a “break- in” period required for the numerous high quality electronic parts used throughout this DAC.
Installation & Placement The MOON 100 D should be placed on a solid level surface. You should avoid placing it near a heat source as this could compromise the DAC’s performance and reliability. Like all digital audio products, the MOON 100 D operates at a very high- frequency;...
Directly above the “Standby” button is a vertical array of six (6) red LED’s to indicate the sampling frequency of the digital input signal: 192 kHz, 176.4 kHz, 96 kHz, 88.2 kHz, 48 kHz and 44.1kHz. Only when the MOON 100 D has successfully locked onto an input signal will one of these LED’s illuminate.
MOON 100 D Digital-to-Analog Converter Rear Panel Connections Figure 2: MOON 100 D Rear panel The rear panel will look similar to Figure 2 (above). On the left side is a pair of single-ended RCA analog audio output connectors. You should connect these to a single-ended stereo analog input on your preamplifier or integrated amplifier. Don’t hesitate to use good quality interconnect cables.
Once the 100 D is connected to an AC source it will be in “Standby mode”. When you press the “Standby” button on the front panel, the 100 D will be ready for use and the blue LED will illuminate.
MOON 100 D Digital-to-Analog Converter Specifications Type ............... Solid State Front Panel Controls ..........Standby / Input Selector LED Indicators ............Locked Sampling Frequency / Input Digital Input Types ..........S/PDIF (RCA) x 1 USB x 1 TosLink x 1 Digital Input Impedance (S/PDIF) ......