MOON 750 D Digital-to-Analog Converter / CD Transport Important Safety Instructions Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block ventilation openings. Install in accordance with the manufacturer’s instructions.
Page 3
To prevent shock hazard, all three connections must ALWAYS be used. Connect the MOON 750D only to an AC source of the proper voltage; Both the shipping box and rear panel serial number label will indicate the correct voltage. Use of any other voltage will likely damage the unit and void the warranty AC extension cords are NOT recommended for use with this product.
Before setting up your new MOON 750D, we encourage you to please read this manual thoroughly to properly acquaint yourself with its features. We hope you enjoy listening to the MOON 750D DAC / CD Transport as much as the pride we have taken in creating this fine audio product.
Installation & Placement The MOON 750D Reference DAC / CD Transport is very heavy. It requires reasonable ventilation to maintain an optimum and consistent operating temperature. Consequently, it should be placed in a location with empty space around it for proper heat dissipation.
MOON 750 D Digital-to-Analog Converter / CD Transport Front Panel Controls Figure 1: MOON 750D Front panel The front panel will look similar to Figure 1 (above). The large digital display window indicates the track number of the compact disc currently playing (or the total number of tracks in stop mode) and corresponding time information.
Page 8
750D successfully locks onto the digital signal, the four dashes will be replaced by the sampling rate of this digital signal. When the signal cannot be locked onto, “----” remains in the display window. The MOON 750D is capable of processing an external digital input signal at one of the following six (6) different sampling rates: 44.1kHz, 48.0 kHz, 88.2kHz, 96 kHz,...
SimLink for more details. Your MOON 750D DAC / CD Transport has a 1/8” mini jack input for use with aftermarket infrared remote control receivers. The “IR in” connector is located immediately to the right of the “SimLink” connectors.
SimLink™ chain; no one particular component operates as the main communications controller. In the event that you are using your MOON 750D with an older MOON product such as a P-7, P-8 or i-7, you will need to update the software of the older product to allow for complete SimLink™...
For example, when one conductor is carrying a signal of +4 Volts, the other will be carrying a signal of –4 Volts. When these two inverted signals on a balanced line are output from the MOON 750D, any noise picked up by the interconnect will be eliminated since a differential circuit amplifies only the difference between these two signals: Noise on a balanced interconnect will be equal on both conductors and therefore not be processed.
Balanced Pin Assignment: Pin 1........ Ground Pin 2........ Positive Pin 3 ......Negative NOTE: In the event that you require the RS-232 codes for your MOON 750D, please contact Simaudio Ltd. directly by either email (service@simaudio.com) or by toll-free telephone (877-980-2400).