moon 380D Neo Series Owner's Manual

32-bit digital-to-analog converter
Hide thumbs Also See for 380D Neo Series:

Advertisement

Quick Links

380D
Series
32-bit Digital-to-Analog Converter
Owner's Manual

Advertisement

Table of Contents
loading

Summary of Contents for moon 380D Neo Series

  • Page 1 380D Series 32-bit Digital-to-Analog Converter Owner’s Manual...
  • Page 2 380D Nēo Series...
  • Page 3: Important Safety Instructions

    EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. FCC information for MOON 380D Digital-to-Analog Converters equipped with the MiND Music Streamer module: This unit contains Transmitter Module FCC ID : ZUCSEDMP3. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
  • Page 4 Nēo 380D, immediately disconnect it from the component. To completely disconnect this AC mains and take it to your MOON dealer for a apparatus from the AC mains, disconnect the complete check-up. power supply cord plug from the AC receptacle.
  • Page 5: Table Of Contents

    Owner’s Manual Table of Contents Introduction Unpacking Installation & Placement Front Panel Controls Rear Panel Connections SimLink™ Operating the Nēo 380D Balanced Operation Remote Control Operation Specifications www.simaudio.com Simaudio Ltd., 1345 Newton Road Boucherville, Québec J4B 5H2 CANADA Date Code: 20150309...
  • Page 6: Introduction

    380D Nēo Series Introduction Digital Audio Signal Processing using M-AJiC32 (MOON Thank you for selecting the MOON Nēo 380D Digital- Asynchronous Jitter Control in 32-bit mode) to-Analog Converter (DAC) as a part of your music/cinema system. This component has been...
  • Page 7: Unpacking

    Owner’s Manual Unpacking The Nēo 380D should be removed from its box with care. The following accessories should be included inside the box with your Digital-to-Analog Converter: AC power cable ‘CRM-2’ remote control with two ‘AA’ batteries ‘SimLink™’ cable with 1/8” mini plug terminations on each end Wi-Fi antenna for “MiND”...
  • Page 8: Front Panel Controls

    380D Nēo Series Front Panel Controls Figure 1: Nēo 380D Front panel The front panel will look similar to Figure 1 (above). The large digital display window indicates the selected digital input (“D1” thru “D8”) its corresponding sampling frequency in kHz (“44.1” thru “192.0”) of the source material currently being played.
  • Page 9: Rear Panel Connections

    Owner’s Manual A corresponding red LED, located to the right of the If your Nēo 380D is equipped with the optional “MiND” display window, will turn onbased on selected input music streaming module, the assigned input is “D9”, the type: “TOSLINK” (for “D6” and “D7”) , “S/PDIF” (“D3”, “D4” sampling rate will appear in the display as it does for and “D5”), “AES/EBU”...
  • Page 10: Simlink

    If you are using your Nēo benefits of high quality cables for your system, and superior 380D with an older MOON product such as a P-7, P-8 or quality AC wall outlet. i-7, you will need to update the software of the older product to allow for complete SimLink™...
  • Page 11: Balanced Operation

    Owner’s Manual Balanced Operation When using an unbalanced interconnect, the audio other. For example, when one conductor is carrying a signal runs through both the center wire and the signal of +4 Volts, the other will be carrying a signal of – shield/ground wire.
  • Page 12: Remote Control Operation

    The Nēo 380D Digital-to-Analog Converter uses the ‘CRM-2’ full-function remote control (figure 6). It operates on the Philips RC-5 communication protocol and is can be used with other Simaudio MOON components. The ‘CRM-2’ remote uses two AA batteries (included). To install them, simply slide the back plate off in the direction of the arrow;...
  • Page 13 Owner’s Manual Remote operation with multiple MOON components Figure 4: Remote Operation with 12V Trigger In figure 4 we have a Nēo 380D, equipped with both the “MiND” and variable output options, connected to a 330A Amplifier via their respective 12V triggers (using a 1/8” mini-jack cable); The 12V trigger output on the 380D is connected to the 12V trigger input on the 330A.
  • Page 14: Specifications

    380D Nēo Series Specifications Configuration Balanced Differential, Stereo Digital / Analog Power Supply Transformers 25VA / 10VA Power Supply Capacitance 26,400μF Digital Filter / Digital-to-Analog Converters ESS ES9016 Sabre 32-bit Hyperstream™ Frequency Response (full range) 2Hz - 100kHz +0/-3dB THD @1kHz, 0dBFS (A-weighted) <...
  • Page 15 Owner’s Manual Specifications (cont’d) Balanced Pin Assignment: Pin 1 Ground Pin 2 Positive Pin 3 Negative Optional MiND Music Streamer: Signal Input – Wired 100Base-T RJ45 Ethernet interface Signal Input – Wireless IEEE 802.11 b/g/n Wi-Fi interface NOTE: If you require the RS-232 codes for your Nēo 380D, please visit the "Contact Us" page and complete the "Information request"...
  • Page 16 380D Nēo Series...

Table of Contents