moon 380D Neo Series Owner's Manual page 11

380D Digital-to-Analog Converter
Remote Control Operation
Figure 6: CRM-2 Remote Control
____________________________________________________________________________________
(cont'd)
The MOON 380D Digital-to-Analog Converter uses the 'CRM-2' full-function
remote control (figure 6). It operates on the Philips RC-5 communication protocol
and is can be used with other Simaudio MOON components.
The 'CRM-2' remote uses two AA batteries (included). To install them, simply slide
the back plate off in the direction of the arrow; insert the batteries in the correct
direction and then replace the back plate.
To engage the 'CRM-2' remote for use with the MOON 380D, you must first
press the button labeled D/A.
The POWER button located on the upper left will switch the integrated amplifier to
either 'Standby' or 'On' mode.
The DISPLAY button turns the front panel display on and off.
The 2 buttons labelled
backwards or forwards, through all eight (8) available inputs. For example, to
switch from "D4" to "D1" you may press either
INPUT ► five (5) times. Pressing and holding down either of these
buttons results in only a single change to the selected input.
The MUTE button turns off the output volume. Pressing the "Mute" button a
second time will reinstate the output volume level back to its current setting.
For MOON 380D's equipped with the optional volume control:
The 2 buttons labelled ▼
VOL results in a decrease in the volume level; Pressing VOL
increase in the volume level. You may either press and hold these buttons down or
press them briefly to make volume adjustments.
◄ INPUT ► allow you to sequentially scroll, either
◄
VOL ▲ allow you to control the volume level. Pressing
INPUT three (3) times or
▲ results in an
▼
11