Main Menu; Installation; Automatic Search - Maxview MXL002 User Manual

MAIN MENU

Pressing the "MENU" button when there is no menu
shown on the screen will access the "Main Menu"
By using the " "/" " and " "/" " buttons you
can move the cursor right, left, up and down. You
can move onto the symbol you want and enter the
sub-menu belonging to that symbol by pressing the
"OK" button.
> There are "Installation", "System", "Timers",
"Extras" and "Games" sub-menus in the "Main Menu".
> You can move the cursor up and down in the
sub-menus by using the " "/" " buttons.
> Exit from the "Main Menu" and sub-menus by
pressing "MENU" or "EXIT" button.

INSTALLATION

> When in the "Main Menu" go to "Installation" by
using " "/" " and " "/" " buttons and press the
"OK" button. The "Installation" sub-menu is displayed.
> There are "Satellite", "Transponder", "Manual Edit /
Search" and "Automatic Search" options in this menu.
22
TRANSPONDER LIST
> While in the "Main Menu", go to "Installation" by
using " "/" " and " "/" " buttons and press the
"OK" button. Press the "OK" button again on "Trans-
ponder" option. The "Transponder List" sub-menu is
entered.
> There is a transponder list of a particular satellite in
the left column and the program list belonging to that
transponder in the right column shown in the
"Transponder List" menu. Press the "RED" button
to select a satellite. When the "GREEN" button is
pressed, the cursor moves to the "Program List"
column. You can add a new transponder by pressing
the "BLUE" button or you can delete a transponder by
pressing the YELLOW" button.
> While in the "Transponder List" menu, go to any
transponder and press the "OK" button.
"Transponder" menu appears. There are "Ops. Menu"
and "Search" options in this menu.
> Press the "OK" button when "Ops. Menu" is
selected. "Transponder Settings" menu is accessed.
Select the satellite you want to make changes to by
using " "/" " buttons.
> By using " "/" " buttons, you can highlight
"Frequency", "Symbol Rate" and "Polarity". By using
" "/" " or number buttons on the remote control
their values may be changed. By viewing the Signal
Strength and Signal Quality at the bottom of the menu
it can be seen if the correct information has been
entered. If it has, press the "BLUE" button to store the
information.
23