Temporary Installation Of A Disengaged Track - Honda HP400 Owner's Manual

Temporary installation of a disengaged track
In the unlikely event that a track slips off the sprockets during operation,
proceed with the following:
1. Stop the engine (refer to page 20).
2. Remove any load in the carrier, by hand. Do not empty it by dumping the
carrier.
3. Move the power carrier to a flat surface and support on wood blocks in two
locations (so the wheels are off the ground). Dump the carrier.
-1 A
carrier with a disengaged track will fall over if the carrier
is dumped, unless first secured with wood blocks.
4.
5.
Loosen the track tension lock nuts and tighten up the inner nut as far as
will go. (This is done in order to facilitate the mounting of the track.)
Remove the sprocket bolts.
FRAME
WRENCH 14 x 10
LOCK NUTS
WRENCH 19
\
SPROCKET
BOLTS
it
WOODEN BLOCKS
43