Honda 2010 Accord Sedan Owner's Manual page 330

4. Install the new bulb, and turn it
one-quarter turn clockwise to lock
it in place.
5. Push the electrical connector onto
the bulb.
6. Turn on the headlights to test the
new bulb.
7. Driver's side on V6 models
Reinstall the air intake cover and
duct securely. Reinstall the
fastener and secure it by pushing
on the head until it locks.
Passenger's side
Reinstall the engine coolant
reserve tank.
Low Beam Headlight
HOLDING CLIPS
To change the passenger's side
1.
bulb, start the engine, turn the
steering wheel all the way to the
left, and turn off the engine. To
change the driver's side bulb, turn
the steering wheel to the right.
2. Use a flat-tip screwdriver to
remove the two holding clips from
the inner fender.
2010 Accord Sedan
BULB
3. Pull the inner fender cover away
from the fender and bumper.
4. Remove the bulb by turning it
approximately one-quarter turn
counterclockwise.
5. Remove the electrical connector
from the bulb by pushing on the
tab to unlock it, then slide the
connector off the bulb.
Lights
TAB
CONTINUED
327