Honda 2010 Accord Sedan Owner's Manual page 193

Playing the XM Radio (Models with navigation system)
CATEGORY ( ▼ or ▲ − )
either side of the bar to select
another category. You can also
change a category by pushing the
interface selector left or right.
The scan function gives
SCAN −
you a sampling of all channels while
in the channel mode. In the category
mode, only the channels within that
category are scanned. To activate
SCAN, press the SCAN side of the
SCAN/A.SEL bar. To scan with the
interface dial, scroll down, and push
interface selector to the right. You
will see SCAN on the screen and
center display.
The system plays each channel in
numerical order for a few seconds,
then selects the next channel. When
you hear a channel you want to
continue listening to, push the
interface selector to the right again
or press the SCAN side of the bar to
cancel.
190
Press
Preset − You can store up to 12
preset channels using the six preset
buttons. Each button stores one
channel from the XM1 band and one
channel from the XM2 band.
To store a channel:
1. Press the
up by pushing the interface
selector up. Either XM1 or XM2
will be shown on the display.
2010 Accord Sedan
2. Use the tune, skip (seek), or scan
function to tune to a desired
channel.
XM BAND
In category mode, only channels
within that category can be
selected. In channel mode, all
channels can be selected.
3. Pick the preset button you want
for that channel. Press and hold
the preset button until you hear a
beep. You can also pick the
number with the interface dial.
Select your desired number and
press and hold ENTER on the
interface selector.
Repeat steps 2 and 3 to store the
4.
first six channels.
button or scroll