Connection To An Audio Visual Device - Hitachi LCD Monitor User Manual

INSTALLATION INSTRUCTIONS (continued)

Connection to an Audio Visual Device

(1) Make sure that the power switch of the monitor is turned off.
(2) Make sure that the power switch of the audio visual device is turned off.
(3) Use a commercially available cable and connector to connect the signal input terminal on the rear panel of this device
and the signal output terminal of the audio visual device.
Set-Top Box
Antenna
DVD Player
• If a component input terminal and a composite input terminal of AV1 and AV2 connect to the monitor at the same time, the component input
would govern.
• If a video equipment with an S video output terminal is used, cabling by the S video cable is recommended to provide finer video quality.
(If an S video input terminal and a video input terminal of AV3 or AV5 (side input) connect to the monitor at the same time, S video input
would govern.)
• If the OUTPUT (Monitor) terminal is connected to an external monitor with a 75 Ohm terminal, it is possible to view the same image as on
the main unit. But it is possible to monitor only the composite video signal from AV1 ~ AV5 input or the S video signal from AV3 and AV5
that is displayed on the screen at the time.
• Secure connecting cables to the stand with the provided clamps.
HDIM*
• HDMI (High-Definition Multimedia Interface) is a digital interface based on DVI (Digital Visual Interface), which is an added function for
audio visual equipment.
- It does not have degradation by transmission since it is digital.
- With only one cable, it is possible to transmit both picture signals and audio signals.
• In case of using analog audio when connecting with DVI-HDMI transformation connector, use analog audio terminal for AV1 input.
Speaker (R)
Power
Cord
HDMI*
VTR
VTR
[An example of connecting audio visual devices]
Monitor (rear panel)
DVD Player
Side Input
Speaker (L)
VTR
13