Honda 00X31-TK6-6100 Owner's Manual page 272

Lights
Replacing Rear Bulbs
LIGHT ASSEMBLY COVER
1. Open the tailgate. Place a cloth on
the edge of the light assembly
cover to prevent scratches.
Remove the cover by carefully
prying in the notch on its middle
edge with a flat-tip screwdriver.
266
2. Determine which of the three
bulbs is burned out: stop/taillight,
back-up light, or turn signal light.
3. Remove the socket by turning it
one-quarter turn counterclockwise.
4. Remove the burned out bulb from
the socket by pulling it straight out
of its socket.
5. Install the new bulb in the socket.
6. Turn on the lights to make sure
the new bulb is working.
7. Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
8. Reinstall the light assembly cover.