Honda 00X31-TK6-6100 Owner's Manual page 269

4. Unclip the end of the hold-down
wire from its slot. Pivot the wire
out of the way, then remove the
bulb.
5. Install the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
HOLD-DOWN
WIRE
INSPECTION WINDOW
6. Make sure that the hold-down wire
is installed properly and securely.
You can check its installation from
the inspection window on the
headlight assembly.
7. Install the rubber seal over the
back of the headlight assembly.
8. Push the electrical connector onto
the new bulb. Make sure it is
connected securely. Turn on the
headlights to test the new bulb.
Replacing a Parking Light/Front
Side Marker Bulb
1. Open the hood.
2. Remove the socket by turning it
one-quarter turn counterclockwise.
3. Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
4. Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
CONTINUED
Lights
263